#dynaCERT $DYA $DYFSF Announces PIT Group #Test #Results Overall #Positive

dynaCERT Inc. (TSX VENTURE: DYA) (OTCQB: DYFSF) is pleased to announce the complete report on the PIT Group testing for Fuel Consumption and Emissions Tests of the HydraGENTechnology.

As previously reported in our press release dated September 21, 2017, PIT Group report states “The results are showing significant decreases in emission levels between baseline and final measurements, of almost half for carbon monoxide (CO), total hydrocarbons (THC), and for mono-nitrogen oxides (NOx).”  Testing verified that the HydraGEN™ HG1 unit reduced emissions of CO by 48.1%, THC by 50.0%, and NOx by 46.1%, all of which exceeded our estimates. This puts dynaCERT and the HydraGEN™ technology firmly into the Hydrogen arena and provides companies worldwide the opportunity to benefit from the Carbon Credit economy with proven Carbon Emission Reduction Technology.

As reported on September 21, 2017, in the Phase One test period the test truck was operated for 36 days from June to August 2017, this operation was not continuous as had been planned in order to decarbonize the engine with the HG1 unit. As a consequence, the test engine did not meet the necessary planned break-in requirements for achieving expected fuel efficiency, but such break-in is not required to realize emission reductions.  dynaCERT elected to continue the fuel consumption testing to Phase Two using these same vehicles to maintain continuity and ensure proper test procedures were followed.

The subsequent Phase Two testing by the PIT Group on the test vehicles was conducted on October 31st, 2017 which by this date had the test vehicle travel double the previous distance.  PIT then followed the industry standard test procedure based on TMC Fuel Consumption Test Procedure – Type II, RP 1102A (TMC 2016) as was done in the Phase One testing.  Performance of the HydraGEN™ HG1 unit reduced fuel consumption by 5.9% when run at a constant speed of 105 kilometres/hour for 100 kilometers on a flat track. Please see www.dynaCERT.com for a copy of the PIT Group report titled “Fuel Consumption and Emissions Tests of the HydraGEN™ Technology from dynaCERT”.

The Company is very pleased with the results of this test and confident that due to increased torque and power from the addition of our technology to diesel engines, better results can be achieved on real on-road conditions and can improve over time while in use.  These new PIT Group results, together with previous testing at the Automotive Centre of Excellence (“ACE”) as previously reported in the Company’s Press Release of November 15, 2016, indicate the important capabilities of the HydraGEN™ technology. Moreover, the various conditions of the ACE testing which emulated varying road conditions with a dynamometer, showed that while altering the flow of gasses of H2/O2 with our HydraGEN™ unit, test results verified a range of fuel consumption reductions from 2.7% to 19.2%.

Additional Benefits of HydraGEN™ Technology

Many additional benefits of the dynaCERT HG1 and HG2 line of HydraGEN™ technology point to a very short Payback Period for users. The Company reports that certain users of existing HydraGEN™ technology who measure performance and cost-saving results continuously have experienced significant reductions in diesel exhaust fluid (DEF) consumption, significant reductions in diesel particulate matter, resulting in fewer filter (DPF) changes and reductions in the number of annual oil changes. These changes of trucking costs have led to reduced down time of truck usage, reduced costs and reduced truck driver annoyances and also reduced fleet management aggravations. These additional benefits combined with the Company’s new reduced pricing strategy can reduce the Payback Period of the Company’s products to under one year and even lower Payback Periods in numerous circumstances. In quantifying such benefits to end users, the Company has considered the cost of filters for Class 6-8 trucks which can reach and exceed 3 replacements per year at a cost of filters of up to US$3,000 each, DEF at a cost of US$6/gallon and Oil changes at a cost of US$200 per change.

dynaCERT Unveils Advantageous New Pricing and Improved Product Design

The Company is pleased to report that new pricing and innovative designs of its HydraGEN™ technology has been unveiled in order to make the Company’s products more attractive to intended users of all the Company’s line of products. The Company is unveiling its new complete and improved product line as follows:

Line of HydraGEN ™ Technology Products

Currently, the Company has improved both lines of its current products:

  • The HG1 product line includes two product line selections:
    1. The all-new HG1 4.5T Unit for 10 to 15 litre turbo diesel engines such as for the Class 6-8 truck market, off-road equipment & power generator market, and,
    2. The current HG1 5T Unit for 5-10 litre turbo diesel engines which lends itself mainly to smaller trucks such as used in many overseas countries such as India and smaller diesel-powered machinery.
  • The HG2 product line which is designed to be smaller and more compact than the HG1 series, currently lends itself to smaller 1 to 5 litre turbo and non-turbo diesel engines and the significant Reefer market (see press release of 21 September 2017).

Improved Design of the HydraGEN™ HG1 Unit

The Company has completed the design of its new HG1 4.5T Unit, which is now available to its customers, and anticipates that the new HG1 4.5T Unit will lower the Payback Period to end users, substantially more than existing HG1 2.5T Units currently in use.

With the Company’s new pricing strategy, and when reviewing the combined financial benefits of the PIT-tested HG1 unit, as described above, the Payback Period at new list prices is calculated to be under 12 months for those targeted vehicles traveling approximately 11,000 miles (18,000 kms) per month.

“We’re excited to report these very encouraging results which verify, once again, that our HydraGEN™ technology works to the benefit of our clients,” says Robert Maier COO and Chief Engineer of dynaCERT.

Jim Payne announced, “We, at dynaCERT, are confident that the new pricing of our HG1 Units, combined with the new technological benefits provided by our upcoming HG1 4.5T Unit, will enable all our clients to achieve their much-needed emissions reductions and important cost benefits going forward. Our 2017 shipments have been delayed by the typical start-up, technological and logistical issues which many innovative companies encounter in their first year of commercial operations. To ensure the highest quality assurance, we expect that our new HG1 4.5T models will not be shipped in time to be recorded in the 2017 fiscal year, but dynaCERT is preparing its sales, marketing and production facilities to record sales of its new HG1 4.5T Units in Q1 2018 and also initiate the launch of its HG2 Units shortly thereafter.”

dynaCERT $DYA $DYFSF Provides #Corporate Update

dynaCERT_web Jan 2017

dynaCERT (TSX.V-DYA OTCQB:DYFSF) reports that it has filed a claim in Ontario Superior Court for damages in the amount of approximately $47.7 million to recover costs, lost revenue and damages associated with the non-functioning electronics from a previous supplier and the resulting delay in production and deliveries.  A re-design of the electronic system began in early June and was completed in late August.  The Company has shifted component production to another supplier.

Operations:

HG1 units advance in their commercial stage.  All units in the field have been updated, or are in the process of being updated, with the most recent technology, including the latest software, to ensure optimum performance. Updated HG1 units are available for shipping by dynaCERT and we expect to make available for shipping our HG2 units near the end of this year.

dynaCERT reports that the testing of the SMART ECU2 has now been completed and regulatory approvals were successfully obtained for the use of our new exclusive technology for use throughout all of North America.

Our Smart ECU systems, our Electronic Control Units that power our proprietary HydraGEN™ line of products that target reduction of harmful gas emissions and improved fuel consumption, incorporate dynaCERT’s proprietary ECU technology, which has been developed by us after years of extensive trials and research. Meaningfully, dynaCERT now has an approved state-of-the-art capability to accurately track, measure and report on greenhouse gas emissions associated with many proponents operating in a diverse set of trades such as Residential, Industrial, Commercial, Power Generation, Railway, Marine, Aviation, On/Off Road and Agricultural applications including the world-wide diesel trucking industry. The data collected with our proprietary ECU’s can be used to determine the amount of greenhouse gas credits or offsets with a view to certify carbon credits in a scientific manner and moreover, do so quickly and in opportune time.

Initially, the newest miniaturized ECU2 version of our ECU line of technology, will be utilized in dynaCERT’s new HydraGEN™ HG2 units. Production of the new HydraGEN™ HG2 unit is targeted to be underway promptly as procurement of parts and equipment have begun for the new HG2 unit.

PIT Group testing of HydraGEN technology continues. Following the announcement dated September 21, 2017, the break-in period and testing by PIT for fuel consumption is expected to be completed by the first week of November and a report received by mid-November.  Once received and confirmed by PIT, these results are expected to be announced by dynaCERT.

European Market update:

In Europe, dynaCERT is in the process of Homologation Certification in Germany working with TÜV NORD GROUP, the largest German safety organization.  For this purpose, the dynaCERTboard has approved the creation of dynaCERT GMBH as a subsidiary LLC company in Germany, to be wholly-owned by dynaCERT Inc.  This process is expected to be the key final regulatory requirement to permit sales in the European Market. TÜV NORD GROUP is a technical service provider with worldwide activities. Founded in 1869 and headquartered in Hanover, Germany, the Group employs more than 10,000 people in more than 70 countries of Europe, Asia, America and Africa.